CVE-2026-79976

What it is

The MCTP-over-I2C+GPIO target binding in subsys/pmci/mctp/mctp_i2c_gpio_target.c emulates a small pseudo-register file, where the bus controller first writes a register number and then writes or reads payload bytes. The selected register (b->reg_addr) and the data-phase flag (b->rxtx) were never cleared when the controller issued an I2C STOP, so after a completed transfer the target still had a data register selected while the packet buffer that register refers to had already been consumed and set to NULL by mctp_i2c_gpio_target_stop(). A controller on the bus can re-enter the same branch of mctp_i2c_gpio_target_stop() with a NULL buffer using two ordinary transactions and no authentication: first a normal packet write to MCTP_I2C_GPIO_RX_MSG_ADDR followed by STOP (which delivers and frees b->rx_pkt), then a bare read transaction followed by STOP. The failing read_requested() call leaves the stale state untouched and the I2C driver still delivers the STOP callback, which then calls mctp_bus_rx() with a NULL packet. The symmetric case exists on the transmit side, where the stale MCTP_I2C_GPIO_TX_MSG_ADDR selection dereferences b->tx_pkt->end after b->tx_pkt has been cleared and additionally signals b->tx_complete a second time, causing the next outbound packet to be dropped. The dereference happens in the I2C target interrupt handler, so on any target that traps accesses to address 0 the result is a fatal exception and a device reset or halt — a denial of service inflicted by any device able to act as controller on the shared management bus (for example compromised firmware on a peer MCTP endpoint or on the BMC). On parts where address 0 is readable, the impact degrades to a malformed packet buffer being handed to the MCTP stack and lost transmit packets. No attacker-controlled value is written and no confidentiality or integrity boundary is crossed. The fix resets b->reg_addr to MCTP_I2C_GPIO_INVALID_ADDR and clears b->rxtx at every STOP, so a new register must be selected before any data phase can run again. Only builds that opt into the experimental CONFIG_MCTP subsystem with CONFIG_MCTP_I2C_GPIO_TARGET=y are affected.

At a glance

Exploitability

Can be exploited from the same network segment without logging in. High risk of service disruption.

Exploit odds

0.3% chance of exploitation in the next 30 days (EPSS).

Fix

A patch, advisory or fixed version is referenced. Upgrade or apply it.

Timeline

1. 2026-08-25 16:06 UTC ReservedThe CVE id was reserved by its CNA
2. 2026-10-21 19:17 UTC PublishedDisclosed publicly on CVE.org and NVD
3. 2026-11-04 05:19 UTC Last updatedMost recent change to the record

Why it ranks here

• Exploited in the wild: no, CISA does not list it.
• Exploit odds: 0.3% in the next 30 days (EPSS).
• Severity: 7.1 HIGH (CVSS).
• Fix: a patch or advisory is linked.

Details

Published

2026-10-21 19:17 UTC

Last modified

2026-11-04 05:19 UTC

Exploit probability

0.3% · EPSS, next 30 days

Weakness

CWE-476 · NULL pointer dereference

Record status

Awaiting Analysis

Attack profile CVSS 3.1 · 7.1

Attack vector

Adjacent network

Complexity

Low

Privileges needed

None

User interaction

None

Scope

Unchanged

Confidentiality

Low

Integrity

None

Availability

High

Is it in your code?

Hand this to your coding agent. It searches your project for the affected products and checks versions. Nothing leaves your machine.

Read https://cve-list.com/agent/cve/CVE-2026-79976.md and follow it. Check whether this project is affected by CVE-2026-79976. Read only. Don't change anything and don't upload my code. Tell me yes, no or not sure, with the file as proof.

Copy as ticket · More options · Status badge